Filter
Top Products
IMG 1004 Quick Start Guide
Dialogic Corporation Part # 07-8724-00 Page 5 of 7
Connecting and Configuring Network Management Port ‘CTRL’
The information below will provide the user with a basic setup sequence for connecting and configuring the IMG 1004 along
with the GCEMS server to download system software and start configuring the IMG 1004 using the ClientView GUI. On the
rear of the IMG 1004 are the network interfaces. The first interface -CTRL- is a Fast Ethernet port which is dedicated to
network management and VoIP signaling. This port is connected to the GCEMS server and allows the GCEMS server to
access the IMG 1004.
1. Connect up the cables as shown in the first figure below.
2. Once the cables are connected configure FTP and DHCP on the GCEMS server. Locate the MAC address that is printed on
a label located on the rear of the IMG 1004. This will be used in the dhcpd.conf file creation.
For more information on how to set up the services refer to the following sections in the documentation
IMG 1004-Installation and Setup Guide > IMG 1004-Software Installation and Setup
If your setup requires using an SD card to load system software refer to procedures below in Online Documentation.
IMG 1004-Installation and Setup Guide > IMG 1004-SD Card