Filter
Top Products
Dual-Speed Stackable Hubs User’s Guide
Making Connections 25
1. Locate the module slot in the hub’s rear panel.
2. Using a screwdriver, undo the two screws and remove the dust cover
on the module slot.
3. Holding the module component-side up and connector-side in, gently
slide the module along the guides and seat it in the internal connector.
4. Using a screwdriver, replace the two screws and tighten until snug.
We recommend that you retain the dust cover in case you need to remove
the module for an extended period sometime in the future.
Switching Module (DFE-260S)
The DFE-260S switching module is used to allow interconnection between
the 10Mbps and 100Mbps segments in the hub or hub stack. Each hub
stack should have one DFE-260S module (such as the one included in the
DFE-916x) if you wish to allow 10Mbps and 100Mbps stations to inter-
communicate.