Filter
Top Products
DGE-530T Gigabit Ethernet Adapter Card
To test the diagnostic, first disconnect the cable from the remote end node so there is just an
open cable connected to the DGE-530T. Click the appropriate adapter from the tree view above
and then click the Start VCT button. The results which will appear in the table below will display
the cable pairs, the status of the corresponding cable, the distance to the fault, and the status of
the test. If the selected adapter is connected and has an uplink, the Digital Signal Processor
(DSP) will be activated and will report the speed of the connection (10, 100, 1000Mbps) and the
length of the cable.
11