Filter
Top Products
29
TX Rates – Select the data rate. Default is 1-2-5.5-11Mbps.
Preamble Type - Short preamble is the default setting. (High traffic
networks should use the shorter preamble type.) The preamble defines the
length of the CRC block used in communication between the Access Point
and the roaming wireless Network adapters. (Cyclic Redundancy Check is a
common technique for detecting data transmission errors)
Authentication - Select Open system, Shared Key or Auto
Open System - The DI-514 will be visible to all devices on the network. This
is the default setting.
Shared Key - In this mode, in order to access the DI-514 on the network, the
device must be listed in the MAC Address Control List.
Auto - In this mode, all devices on the network can access the
DI-514.
SSID Broadcast - Enable is the default setting. Choose Enable to
broadcast the SSID across the network. All devices on a network must share
the same SSID (Service Set Identifier) to establish communication. Choose
Disable if you do not wish to broadcast the SSID over the network.
Admin
At this page, the DI-514
administrator can change the
system password. There are
two accounts that can access
the Broadband Router’s Web-
Management interface. They
are admin and user. Admin
has read/write access while
user has read-only access.
User can only view the
settings but cannot make any
changes.
Remote Management
Remote Management allows the DI-514 to be configured from the Internet by
a web browser. A username and password is still required to access the
Web-Management interface. In general, only a member of your network can
Tools > Admin