Filter
Top Products
70D-Link DAP-1350 User Manual
Section 3 - Configuration
L2TP
Choose L2TP (Point-to-Point Tunneling Protocol) if your ISP uses a L2TP connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services.
PPTP IP Address:
PPTP Subnet Mask:
PPTP Server IP Address:
Username:
Password:
Reconnect Mode:
Maximum Idle Time:
DNS Servers:
MTU:
Clone MAC Address:
Enter the IP address (Static PPTP only).
Enter the subnet mask.
Enter the Server IP Address provided by
your ISP.
Enter your PPTP username.
Enter your PPTP password and then retype
the password in the next box.
Select Always on, On Demand or
Manual.
Enter the time (in minutes) where the
router will disconnect if idle for the time
specified.
Enter the Primary and Secondary DNS
(Domain Name System) server IP address
assigned by your ISP.
You may need to change the MTU (Maximum
Transmission Unit) for optimal performance
with your specific ISP. The default MTU size
is 1400.
The default MAC address is set to the MAC address on the AP (Access Point). You can click the Clone Your PC’s MAC
Address button to replace the AP’s MAC address with the MAC address of your Ethernet card. It is not recommended
that you change the default MAC address unless required by your ISP.