Filter
Top Products
15
Ethernet Ports (Port 9~16):
These ports support network speeds of either 10Mbps or 100Mbps,
and can operate in half- and full- duplex transfer modes. These ports
also support the automatic MDI/MDIX crossover detection function,
providing true “plug and play” capability. Just plug-in the network
cable to the Switch directly regardless if the end node is a NIC
(Network Interface Card) or switch and hub.
Note: When the port is set to “Forced Mode”, Auto MDI/MDIX will
be disabled.
Rear Panel
AC Power Connector
Reset Button
Figure 4. Rear panel of the Switch
AC Power Connector:
This is a three-pronged connector that supports the power cord. Plug
in the female connector of the provided power cord into this connector,
and the male into a power outlet. Supported input voltages range from
100-240V AC at 50-60Hz.
Reset:
The Reset button is to reset all settings back to the factory defaults.
Note: Be sure that you recorded the settings of your device, as all
settings will be erased when pressing the “Reset” button.