Filter
Top Products
D-Link DGS-1024T Unmanaged Gigabit Ethernet Switch
• Auto-negotiation (NWay) between 10/100/1000 Mbps, half-duplex or full duplex and flow control for
10/100/1000BASE-T ports.
• Gigabit ports support connection bypass mode
Ports
• Twenty-four high-performance NWay Ethernet ports, all of which operate at 10/100/1000 Mbps for
connections to end stations, servers and hubs. All ports can auto-negotiate between 10Mbps, 100Mbps
and 1000Mbps at full or half duplex.
• Two Gigabit Ethernet Combo ports for making 1000BASE-T and Mini GBIC connections
Front-Panel Components
The front panel of the Switch consists of LED indicators, 24 (10/100/1000 Mbps) Ethernet ports and 2 Mini
GBIC Combo ports.
Figure 1 - 1. Front Panel View of the switch as shipped
Comprehensive LED indicators display the status of the switch and the network.
Two Mini GBIC Combo ports for connections to server or network backbone
LED Indicators
The LED indicators of the Switch include Power, 1000M and Link/Act. The following shows the LED indicators
for the Switch along with an explanation of each indicator.
Figure 1-2. LED Indicators
Power
This indicator on the front panel should be lit during the Power-On Self Test (POST).
It will light green approximately 2 seconds after the switch is powered on to indicate
the ready state of the device.
1000M
This indicator on the front panel will light solid green for a port transferring at
1000Mbps. If this LED is dark, the port will be transferring at 10/100Mbps
Link/Act
Each on-board Gigabit Ethernet port has a corresponding indicator. This will light
steady green for a valid link and blink whenever there is reception or transmission
(i.e. Activity--Act) of data occurring at a port.
9