Filter
Top Products
28 Web User Guide
z A network management system is configured. From this management station, you can
access the SNMP, HTTP, and CLI interfaces. You may also choose to allow all IP
addresses to access these management interfaces by choosing the (0.0.0.0) IP address.
z An IP address is configured for the default management interface (1).
z A default gateway address is configured.
NOTE:
In the example below, the possible user options are enclosed in [ ]. Also, where possi-
ble, the default value is provided in { }. If you enter <Return> with no options
defined, the default value is accepted. Help text is in parentheses.
The following example contains the sequence of prompts and responses associated with
running an example D-Link Easy Setup Wizard session, using the input values listed above.
After the switch completes the POST and is booted, the following dialog appears:
U-Boot 0.3.0 (Sep 23 2005 - 14:05:10)
Board: DLink DES-3226L
DRAM: Less than 128MB hence resetting to try 64MB
U-Boot 0.3.0 (Sep 23 2005 - 14:05:10)
Board: DLink DES-3226L
DRAM: 64 MB
Flash: 8 MB
In: serial
Out: serial
Err: serial
Hit any key to stop autoboot: 0
0
## Booting image at a0400000 ...
Image Name: Linux 2.4.20
Image Type: MIPS Linux Multi-File Image (gzip compressed)
Data Size: 1876253 Bytes = 1.8 MB
Load Address: 80001000
Entry Point: 80196048
Contents:
Verifying Checksum ... OK
Uncompressing Multi-File Image ... OK
Starting kernel ...
Broadcom BCM947XX Startup Rev: 1.3
Select startup mode. If no selection is made within 3 seconds,
the Broadcom BCM947XX Application will start automatically...
1 - Start Broadcom BCM947XX Application
2 - Display Utility Menu
Select (1, 2):
Starting Broadcom BCM947XX application...
Console starting...\
SPI unit 0: Dev 0xbc20, Rev 0x01, Chip BCM5324_A1, Driver BCM5324_A1
PCI unit 1: Dev 0x4713, Rev 0x09, Chip BCM4713_A0, Driver BCM4713_A0
SPI device BCM5324_A1 attached as unit 0.
-/enable_irq(4) unbalanced from c007b7a0
Broadcom BCM47xx 10/100 Mbps Ethernet Controller 2002.9.27.0
started!
(Unit 1)>
User: