Filter
Top Products
DSL-300T ADSL Modem User’s Guide
22
7. The Encapsulation values LLC (SNAP) and VC (MUX) are two different methods of encapsulating the
PPP packet. Contact your ISP to make sure which encapsulation is being supported.
8. For most users, the remaining settings will not need to be changed. See your ISP for further information.
9. Click the Apply button when you have entered all the information. The browser window may briefly go
blank. After a few seconds the new connection you just configured will become the active connection for the
Modem.
10. To make your temporarily saved connection permanent, click the Save All button in the System
Commands window on the Tools tab.
Bridge
Make sure you have selected Bridge from the Type: pull-down menu so that you are now configuring setting in
the menu titled “Bridged Connection Setup”. Follow the instructions below to set up the connection.
Figure 3-6. Setup – New Connection (Bridge) window
To configure the WAN connection for Bridge, perform the steps listed below. Some of the settings do not need
to be changed when you first set up the device but can be changed later if you choose.
“Bridge” means a pure bridged connection with no IP address assigned to the Modem. This connection method
makes the Modem act as a bridge, and just passes packets across the DSL port.
1. Type in a Name in the space provided if you wish or leave the default name.
2. Make sure Bridge appears listed as the Type: of connection protocol used.
3. Do not change the VPI or VCI values unless you are required to do so. If these settings are incorrect, the
ADSL connection will not function. Many users will be able to use the default settings. If you are told to
change these, type in the values given to you by your service provider.