Filter
Top Products
12
Punching Holes in Non-Adhesive Labels
You can choose to punch one or two holes in non-adhesive labels so that
the labels can be attached using screws, nails, rivets, and metal or plastic
wires or ties. You can also punch a cable tie slot in one or both ends of the
label.
To punch a hole
1. Insert one end of the cut label into the hole punch slot (L).
2. Lift the cutting handle (I) to the vertical position to punch a hole.
To punch a cable tie slot
1. Insert one end of the cut label into the cable tie slot (K) with the
letters facing down. The letters must face down to ensure the bridge
of the slot is on the same side of the label as the characters.
Make sure to allow enough room for the tie-buckle before
and/or after the letters. A cable tie slot positioned on top of the
characters or a punched hole may cause the tape to jam.
2. Lift the cutting handle (I) to the vertical position to punch the slot.
L
K
I
!