Eaton Electrical 10000L(XL) Power Supply User Manual


 
5
2. Installation
2.1 Unpacking and inspection
1) Unpack the packaging and check the package contents. The
shipping package contains:
A UPS
A User Manual
A Communication Cable
A Battery Cable (for 6000LXL /10000LXL only)
2) Inspect the appearance of the UPS to see if there is any
damage during transportation. Do not turn on the unit and notify
the carrier and dealer immediately if there is any damage or
lacking of some parts.
2.2 Input and output power cords and protective earth
ground installation
1. Notes for installation
1) The UPS must be installed in a location with good ventilation,
far away from water, inflammable gas and corrosive agents.
2) Ensure the air vents on the front and rear of the UPS are not
blocked. Allow at least 0.5m of space on each side.
3) Condensation to water drops may occur if the UPS is
unpacked in a very low temperature environment. In this
case it is necessary to wait until the UPS is fully dried inside
out before proceeding installation and use. Otherwise there
are hazards of electric shock.
Installation and wiring must be performed in accordance with the
local electric code and the following instructions by professional
personnel.
For safety, please cut off the mains power switch before