28
Turning the Projector On/Off
Remove the lens cap and press
oSTANDBY-ON on the projector or
bON on the remote control.
• About the Lamp Indicator
The lamp indicator illuminates to indicate the
status of the lamp.
Green: The lamp is on.
Blinking in green: The lamp is warming up
or shutting down.
Red:The lamp is shut down abnormally
or the lamp should be replaced.
• When switching on the projector, a slight flick-
ering of the image may be experienced within
the first minute after the lamp has been illumi-
nated. This is normal operation as the lamp’s
control circuitry is stabilising the lamp output
characteristics. It should not be regarded as
faulty operation.
• If the projector is put into standby mode and
immediately turned on again, the lamp may
take some time to start projection.
STANDBY-ON button
Note
Lamp indicator
• English is the factory default language. If you
want to change the on-screen display to another
language, change the language according to
the procedure on page 50.
Info
Turning the Projector on
Note that the connections to external equip-
ment and power outlet should be done be-
fore performing the operations written be-
low. (See pages 23 to 28.)
Power indicator
ON button
AC socket
Power cord
Supplied
accessory
Connecting the Power Cord
Plug the supplied power cord into the AC
socket on the rear of the projector.
EIP-1600T_EN_h 06.1.24, 1:05 PM28