Eiki LC-X984 Projector User Manual


 
LC-X999/984
46
This projector has other functions settings: Blue back, Display, Ceiling, Rear, Split wipe, Power management,
Remote control and Lamp age.
See the next page menus figure and settings.
BLUE BACK (On or Off)
When this function is in the “On” position, the projector will project a blue image without video noise on the screen
when the video source is unplugged or turned off.
DISPLAY (On 1, On 2 or Off)
When this function is in the “On 1” position, on-screen displays always appears when adjustments are made.
Although these on-screen displays are very helpful, these may spoil the view if adjustments are made during
presentations. To avoid this, you can keep back certain displays by switching the function “On 2” and “Off”. The
followings are the displays that you can hide.
“On 2” position
• Wait Display (Start up Logo)
“Off” position
• Wait Display (Start up Logo and count-down timer)
Mode Display
• Mute Display
Zoom/Focus Display
• D.Zoom Display
Keystone Display
• Normal Display
CEILING (On or Off)
When this function is in the “On” position, the top/bottom and the left/right
picture reverse capability lets you project from a ceiling-mounted projector.
REAR (On or Off)
When this function is in the “On” position, the left/right picture reverse
capability
lets you project onto a rear projection screen.
SPLIT WIPE (On or Off)
Turn SPLIT WIPE function On in the SETTING menu. The picture will
change into the next one by sliding black image side ways when the input source is changed.
Change the input source by MODE button. The picture is replaced by black image from side ways to the center, and
the next one appears from the center to side ways like drawing the black curtains.
POWER MANAGEMENT (On or Off)
This function turns the Projection Lamp off when the projector detects signal interruption and the projector is not used
for a certain period in order to reduce power consumption and maintain the Lamp-life. (This projector is shipped with
this function ON.) Power Management function operates to turn the Projection Lamp off when the input signal is
interrupted and the projector is not operated over 5 minutes. This function operates as follows:
1. When the signal is interrupted, “No signal” and the counting down (5 minutes)
display appears.
2. After 5 minutes, the Projection Lamp turned off and the READY indicator turns
off. After 1 minutes, the READY indicator flashes and the Lamp can be turned on
again (Power Management mode). In this Power Management mode, the
Projection Lamp is automatically turned on when the input signal connected or
the projector is operated with any button on the Top Control or the Remote
Control.
• Volume Displa
y
• True Display
• No show
Display