Filter
Top Products
24
COMPUTER INPUT
MANUAL PC ADJUSTMENT
This projector can automatically tune the display signals from most personal computers currently distributed. However,
some computers employ the special signal formats which may not be turned by Multi-Scan system of this projector. In this
case, the image may be recognized as a flickering picture, a non-synchronized picture, a non-centered picture or a skewed
picture, and projected improperly.
The MANUAL PC ADJUSTMENT function allows you to manually adjust several parameters to match these special signal
formats. Also, you can store these adjusted parameters in the 5 independent memory areas, enabling you to call up
whenever you need.
Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT button to move the red
frame pointer to the PC ADJUST Menu icon.
1
2
Press the POINT DOWN button to move the red frame pointer to
the item that you want to adjust and then press the SELECT
button. An adjustment dialog box will appear. Press the POINT
LEFT/RIGHT button to adjust value.
Move the red frame pointer to the item
and press the SELECT button.
PC ADJUST MENU
PC ADJUST Menu icon
Adjusts an image as necessary to eliminate flicker from the display.
Press the POINT LEFT/RIGHT button to adjust value.(From 0 to 31.)
Fine sync
The number of total dots in one horizontal period. Press the POINT
LEFT/RIGHT button(s) and adjust number to match your PC image.
Total dots
Adjusts horizontal picture position. Press the POINT LEFT/RIGHT
button(s) to adjust the position.
Horizontal
Adjusts vertical picture position. Press the POINT LEFT/RIGHT
button(s) to adjust the position.
Vertical
Press the SELECT button to show the information of the computer
selected.
Current mode
Adjusts clamp level. When the image has a dark bar(s), try this
adjustment.
Clamp
Press the SELECT button at this icon
to adjust “Clamp,” “Display area (H/V)”
or set “Full screen.”
Press the POINT LEFT/RIGHT
button to adjust the value.
Shows status
(Stored / Free) of the
selected Mode.
Selected Mode
Press the SELECT button
at the Current mode icon
to show the information of
the computer connected.
Current mode