Filter
Top Products
DMX PARTNER
8
8b. Deleting chase steps
1. Press and hold down the “Record“ button and simultaneously press chase buttons 1, 6, 8,1, 6, 8 in
sequence. As a result, the Record LED will illuminate. (Note: if you do not have a DMX controller
connected to the DMX input of the DMX Partner as described in the previous step, you will not
be able to access the Record mode).
2. Select the chase 1-8 you want to delete. The chase LED will flash and the LCD will display the total
amount of chase steps included into the selected chase- “CH:xx“.
3. To view the previously recorded steps, press the same chase button, both chase and record LED’s
will be lit. Use the “Up/Down“ buttons to scroll to the step you would like to delete. Once you find the
step, press the same chase button again so that the chase LED is flashing. (You must exit this
preview mode before you can delete the step).
4. Press the “DELETE“ button. All eight chase LED’s will momentarily flash and the LCD will display
the previous chase step confirming that the step was deleted.
5. Repeat steps 3 & 4 to delete additional chase steps.
6. Press “BLACK-OUT“ twice to exit record mode.
8c. Deleting chases
1. Press and hold down the “Record“ button and simultaneously press chase buttons 1, 6, 8,1, 6, 8 in
sequence. As a result, the Record LED will illuminate. (Note: if you do not have a DMX controller
connected to the DMX input of the DMX Partner as described in the previous step, you will not
be able to access the Record mode).
2. Press and hold down the “Delete“ button, then press the Chase button 1-8 you want to delete. All
eight chase LED’s will momentarily flash and the chase button you selected will not be lit anymore
confirming that the chase has been deleted.
3. Repeat step 2 to delete additional chases.
4. Press “BLACK-OUT“ twice to exit record mode.
Section 9: Recording Shows
1. Connect from your DMX controllers output to the DMX input of your DMX Partner. (When
programming moving lights, it is recommended that you pre program scenes into your DMX controller
before recording chases into the DMX Partner).
2. Press and hold down the “Record“ button and simultaneously press chase buttons 1, 6, 8,1, 6, 8 in
sequence. As a result, the record LED will illuminate. (Note: if you do not have a DMX controller
connected to the DMX input of the DMX Partner as described in the previous step, you will not
be able to access the Record mode).
3. Select the Show button 1 or 2 that you want to record into. Once selected, the show LED will
continually flash and the LCD will display the current show step- “SH:00“.
4. From your DMX controller, select the scene or manually adjust the channels you want included into
your first show step.