Filter
Top Products
DESIGN Brick 70™
©Elation Professional, Los Angeles Ca. 22 www.ElationLighting.com
the fixture. RDMX is on by default. For operational instructions please see Section
9/Page 24 of this manual “Remote DMX addressing.”
No DMX Status – This function dictates how the fixture will function if it looses DMX
signal during normal operation. The default function is set to hold, in which the
fixture will lock into the last DMX signal it received and remain in that position until it
is turned off or begins receiving a new DMX signal. If the fixture is turned on
without any DMX signal, the fixture will automatically go in to sound-active mode.
Available settings are: “Close” – Shutter flags will close. “Hold” – Fixture will remain
at it’s last settings. “Auto” – Fixture will go into stand-alone mode, running the built-in
program.
8.3.2 Fans Control - This function is used to change the functionality of the internal
cooling fans. The available selections are: 1) “AUTO” – The fans will automatically
switch between low and high speeds depending on the internal operating temperature. 2)
“HIGH” – The fans will run in high-speed mode regardless of operating temperature. 3)
“LOW” – The fans will remain in low speeds regardless of internal operating
temperature.
8.3.3 Display Setting – The display is designed to turn off during normal operation to
avoid excessive light in situations that require an extremely dark environment. This
function will adjust the time delay the LCD will remain on before it turns off. This function
is disabled as default.
8.3.4 Temperature C/F – This function changes the temperature the unit will display
from either Celsius or Fahrenheit. Celsius is set as default.
8.3.5 Restore Default – This function is used to restore the factory settings of the
device. All settings will be set back to the default values (shaded). Any edited scenes will
be lost.