Filter
Top Products
4
appliance. If the appliance label states that the charger or adapter
produces a low-voltage DC or AC output (30 volts or less), there will
be no problem powering that charger or adapter.
• Some fans with synchronous motors may slightly increase in speed
(RPM) when powered by the inverter. This is not harmful to the fan
or to the inverter.
• Route appliance cords and extension cords to prevent accidental
pinching, crushing, abrading and tripping people.
• Use safety approved extension cords rated at 15 amps or higher.
• GFCI devices may not work with modified sine wave (MSW) power.
• This inverter is not tested for use with medical equipment.
• This inverter is not tested for use in marine applications.
• In the event of a continuous audible alarm or automatic shut down,
turn the inverter OFF immediately. Do not restart the inverter until the
source of the problem has been identified and corrected.
• When attempting to power lead acid battery chargers, with modified
sine wave, monitor the temperature of the battery charger for
approximately 10 minutes. If the battery charger becomes
abnormally warm, immediately disconnect it from the inverter.
Getting Started
When a motorized appliance or a tool turns on, there is an initial surge of
power to start. This surge of power is referred to as the "starting load" or
"peak load." Once started, the tool or appliance requires less power to
operate. This is referred to as the "continuous load" in terms of power
requirements. You will need to determine how much power your tool or
appliance requires to start up (starting load) and its continued running
power requirements (continuous load).
Power consumption is rated in watts, or it can be calculated from
amperes (amps). This information is usually stamped or printed on most
appliances and equipment. If this information is not indicated on the
appliance or equipment, check the owner's manual. For electrically
sensitive equipment, contact the manufacturer to determine if the device
you are using is compatible with modified sine wave AC.