Filter
Top Products
CHAPTER 3: CONNECTING TO THE NETWORK
Page 16 BRIM-E6 USER’S GUIDE
Caution: Do not touch the ends of the fiber optic strands, and do
not let the ends come in contact with dust, dirt, or other
contaminants. Contamination of the ends can cause problems in
data transmissions. If the ends become contaminated, clean them
with alcohol using a soft, clean, lint free cloth.
To connect a fiber optic link segment to an EPIM-F1, EPIM-F2, or
EPIM-F3:
1. Remove the protective plastic covers from the fiber optic ports on the
applicable port on the module and from the ends of the connectors on
each fiber strand.
2. Attach the fiber labeled 1 to the applicable receive port, labeled RX,
on the module. See Figure 3-2.
Figure 3-2. The EPIM-F1, EPIM-F2 and EPIM-F3
SMA 905 Connectors
SMA 906 Connectors w/
Half Alignment Sleeves
F1
ST Connectors
F2
ST Connectors
F3