Support User Manuals

Enterasys Networks C2RPS-CHAS2 Power Supply User Manual

Open as PDF

of 34

SecureStack C2 Installation Guide 2-1

2

Installation

ThischapterprovidesinstructionstoinstallallthecomponentsofanRPS.

TocorrectlyinstallanRPS,followtheorderofinformationlistedbelow.

Required Tools

Aflat‐bladescrewdriverisrequiredtoinstalltheC2RPS‐CHAS2andC2RPS‐PSMs.

Unpacking Chassis and Power Supply Module(s)

TheC2RPS‐CHAS2andeachC2RPS‐PSMareshippedseparately.Tounpackthese

devicesproceedasfollows:

1. Opentheboxandremovethepackingmaterialprotectingthedevices.

2. Verifythecontentsofeachcartonandcomparethecontentsshippedwiththoselisted

inTable 2‐1andTable 2‐2.

Electrical Hazard: Only qualified personnel should perform installation procedures.

Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de

instalacion.

Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und

qualifiziertes Personal vorgenommen werden.

For information about... Refer to page...

Required Tools 2-1

Unpacking Chassis and Power Supply Module(s) 2-1

Installing C2RPS-PSMs 2-2

Installing C2RPS-CHAS2 into the Rack 2-4

Connecting the PSM Cables and AC Power Cords 2-6

previous next