Enterasys Networks DFE-256MB-UGK Computer Hardware User Manual


  Open as PDF
of 5
 
PN 9033946 Page 1 of 5
DFE Series Module
Memory Upgrade Kit (DFE-256MB-UGK)
Installation Instructions
Before You Begin
These installation instructions describe how to upgrade the Dual-Inline Memory Module (DIMM)
on a DFE series module from 128 MB to 256 MB using the 256 MB SDRAM DIMM included in this
DFE-256MB-UGK
kit.
To help eliminate any potential problems during or after installation, read and understand all of
the instructions in this document and in the release notes supplied with the DFE-256MB-UGK
upgrade kit.
If there are missing or damaged parts, or you need help installing the DIMM, contact Enterasys
Networks for assistance. (Refer to “Getting Help” at the end of this document.)
Kit Parts
Required Tools
Caution: Only authorized personnel should install the DFE Series Module Memory Upgrade Kit
(DFE-256MB-UGK).
Note: Access to advanced routing features, such as Protocol Independent Multicasting
(PIM) and Load Share Network Address Translation (LSNAT) currently require memory
greater than 128 MB. Please consult the Release Notes to see which additional features
require this memory upgrade.
Qty Item
1 256 MB SDRAM DIMM assembly
1 URL Location Card
1 This document (PN 9033946)
Qty Item
1 Antistatic wrist strap (not supplied)
next