Support User Manuals

Enterasys Networks A2H254-16 Switch User Manual

Open as PDF

of 80

Connecting AC and RPS-SYS Power

SecureStack A2 Installation Guide 3-17

C2RPS-SYS Redundant Power System

Ifyouareinstallinganoptionalredundantpowersystem(C2RPS‐SYS),refertothe

installationinstructionssuppliedwiththeSecureStackRPS.Theswitchisconnectedtoa

C2RPS‐PSMusingaC2RPS‐PSMCable.

Figure 3-10 Accessing the RPS Connector

Ifyouareinstallingtheswitchasastandaloneswitch,proceedto“ConnectingtoConsole

PortforLocalManagement”onpage3‐18.Ifyouareinstallingswitchesinastack

configuration,applypowertoeachswitchinorder,accordingtotheprocedureyouusein

“ConfiguringSwitchesinaStack”onpage3‐12.

1 RPS coverplate 3 Screw holes for coverplate

2 Retaining screws to fasten plate

Caution: To prevent damaging the switch, DO NOT connect a Power over

Ethernet-compliant Redundant Power System (C2RPS-POE) to the redundant power

supply connector. The switch is only compatible with the SecureStack C2RPS-SYS

redundant power supply system.

Precaución: No conecte una fuente de poder redundante (RPS) SecureStack PoE

(C2RPS-POE) al cable de corriente. De lo contrario, el dispositivo puede dañarse.

previous next