Filter
Top Products
4
5
Feed the posterboard into the paper slot until it
meets resistance.
6
Align the board with the scale on the roll paper
cover.
7
Return the paper lever to the locked position. Then
close the front cover.
8
Press the Pause button. The board feeds into the
printing position automatically.
9
Run your print job. After it is finished, the
posterboard stays in the printer.
10
To remove the print, hold it and release the
paper lever.
Loading and Using Cut Sheet Paper
Loading and Using Cut Sheet Paper
1
Remove any roll paper from the paper path. Make
sure the printer is on and the roll paper cover is
closed.
2
Press the Paper Source button until the icon
appears on the LCD.
3
Release the paper lever. If the lever is locked, press
and hold the button for 3 seconds to unlock it.
Note: If you’re printing on small sheets or fine art
paper, do not release the paper lever.
4
Feed the sheet into the paper slot until it meets
resistance. Make sure the right and bottom edges
of the paper are straight and aligned with the
horizontal and vertical lines on the printer.
5
If you released the paper lever, return it to the
locked position.
6
Press the Pause button. The sheet feeds into the
printing position automatically.
Caution: To avoid damaging the printer, never move
the paper lever during printing, or while the Power
or Pause light is flashing.
7
Print your page. After it is finished, the sheet stays
in the printer.
8
To remove your print, press the button.
Printing on Posterboard
When you print on posterboard or other thick media
(more than 19 mil thick), you should open the front
cover before loading as described below.
1
Make sure the printer is on and the roll paper cover
is closed.
2
Press the Paper Source button until the icon
appears on the LCD.
3
Release the paper lever. If the lever is locked, press
and hold the button for 3 seconds to unlock it.
4
Open the front cover. (The cover has a lip that acts
as a paper support when the cover is open.)