Filter
Top Products
Monitoring the Projector Over a Network 93
■ SNMP
If you’re a network administrator, you can use the SNMP
option to enter a trap IP address. This lets you receive trap
alerts for the projector on a computer running the SNMP
Manager software.
■ Mail
When enabled, the projector sends you an e-mail alert if it has
any problems. For instructions on setting up e-mail alerts, see
the next section.
■ Projector Name
Enter a name for identifying the projector over the network.
Using Projector E-mail Alerts
When this feature is enabled, the projector sends you an e-mail alert if
it has any problems.
1. Press the
Menu button, select the Network menu, and press
Enter.
2. Select
Mail and press Enter.
3. Select the following settings as necessary:
■ Mail Notification
Select On to enable sending of an e-mail if there is a problem
with the projector.
■ SMTP Server
Enter the IP address for the SMTP server for the projector.
You can enter a number from 0 to 255 in each field of the
address.
■ Port Number
Enter the SMTP server’s port number. The default value is
25. You can enter a numeric value from 1 to 65535.
■ Destination Address 1/2/3
Choose one of the Destination Address fields, then enter
the e-mail address where you want to receive a message when
a problem occurs.
note
You can also set e-mail alerts
from EMP Monitor (see
page 98).
note
If a critical problem develops
with a projector which
causes it to suddenly stop
working, it may not be
possible for the projector to
send a message.
If Standby Mode is set to
Network On in the
Extended menu, the
projector can still be
monitored even if the
projector is in standby mode
(when the power is off).