Filter
Top Products
BTP-M170 User’s Manual
4.6 Loading the Roll Paper
4.6.1 Confirming the media
After connecting the power adaptor and signal cable, you can load the media for printing.
Before loading roll paper, you should confirm the type of the paper to be used for printer. The
default paper type is continuous paper. If marked paper will be used, please contact SNBC or
your local agents.
4.6.2 Loading/replacing roll paper
1) Turn on the printer power.
2) Open top cover of the printer and confirm paper head is trimmed. Drop roll paper into
paper cabinet as shown.
3) Insert paper head into paper inlet around paper guiding platen and wait for printer to
feed paper automatically. When paper is end, the printer will be off-line.
4) After 1s, paper will feed automatically about 35 mm. If the media is marked paper, the
printer will detect the marks after feeding paper and position it at the tear-off point.
5) After about 3s, PAPER LED will flash. Press FEED button and the printer will enter into
on-line status.
Caution:
8
Adjust the paper guide according to the paper type used: hold the hole at the
backside of paper guide to turn it up and take it off; select proper position to insert
paper guide vertically according to paper width; pay attention to the winding direction
of paper which should match the printer requirement.
Note: A: 76±0.5mm
B: 69.5±0.5mm
C: 57.5±0.5mm
- 10 -