Epson CMD-2260 Computer Drive User Manual


 
SOFTWARE INSTALLATION
1. Insert the installation disk into Drive A or Drive B. (Not required for Windows ‘95 installations - see page
20).
2. At the DOS prompt, type the drive letter where the disk is inserted, followed by a colon. Press ENTER
3. Type install and press ENTER. The following menu appears:
4. The next menu allows you to specify where the MS-DOS MSCDEX.EXE tile is located.
The default selection is C:\DOS.
Chose OK when you have completed your selections If there were no
errors, the setup menu appears as shown in (6) below.
5. If the MSCDEX.EXE tile is not on your drive, or you have not chosen the correct directory, the following
menu appears.
The MSCDEX.EXE tile is included on your DOS 6.0 or higher installation disks. If this tile
was not installed on your drive during your initial DOS installation you can extract the tile directly off the
installation disks.
If this tile is not included on your installations disks you can contact Microsoft Technical
support.
ATA/IDE Owner’s Manual
10