Epson ELPMBPJF Projector Accessories User Manual


 
ISSUED: 01-23-07 SHEET #:055-9498-1
Visit the Peerless Web Site at www.peerlessmounts.com
8 of 10
For Technical Support Contact Peerless Mounts at 1-800-729-0307 or 708-865-8870.
Attach adapter plate (L) to projector using one
screw (M, N, O or P) for each channel as shown.
Tighten all screws, while keeping the center of gravity.
Be sure that adapter plate (L) is straight. Adjust the feet
of the channels to keep the adapter plate level. Tighten
all screws with 4 mm security allen wrench (B) or
wrench provided with projector mount, while keeping the
center of gravity. If M3 screws are used, tighten using 2
mm security allen wrench (Q).
NOTE: Projectors may require different size screws for
mounting. Use a combination of screws (M, N, O or P)
and foot adjustment that will result in channels of
adapter plate (L) fitting tightly against projector.
Important: In order to properly engage the threads in
the mounting holes, the screw must be turned at least
3 full turns.
NOTE: If using screw (M), place washer (R) between
screw (M) and foot of channel.
FOOT OF
CHANNEL
L
M,N, O
or P
4
Attach projector, with adapter plate already on it,
to the projector mount (A) by inserting the
projector mount (A) into the adapter plate
connection and twisting until the adapter plate will
no longer turn (about 75°). The spring loaded
captive screw should line up with a corresponding
hole on the adapter plate (this should line up
automatically when the two are connected). Push
down and tighten the spring loaded captive screw
to secure the adapter plate to the mount. If not
using the optional security feature, fasten thumb
screw (D) in the hole opposite the spring loaded
captive screw.
OPTIONAL: For security option, use #10-32 x
3/8" security screw (E) in the hole opposite the
spring loaded captive screw. Tighten with security
allen wrench (B). This will prevent the projector
from being removed.
NOTE: Be sure to only use the #10-32 x 3/8"
screw (E) (or the thumb screw (D) opposite
the spring loaded captive screw.
LEG
3
Attaching Adapter Plate to Projector Mount
CAPTIVE
SCREW
WOOD
JOIST
CEILING
CUTAWAY VIEW
OF CEILING
PLATE (G)
2
1
PROJECTOR
L
E
D
A
Do not lift more weight than you can handle! Use
additional man power or mechanical lifting equipment
to safely handle placement of the projector!
WARNING