Filter
Top Products
13
Installing the
Projector
Preparing the Remote Control
Inserting batteries into the remote control
The remote control is not supplied with batteries already inserted. Insert the accessory batteries
before using the remote control.
QTip: If delays in the responsiveness of the remote control occur or if it does not operate
after it has been used for some time, it probably means that the batteries are
becoming flat. If this happens, replace the batteries with two new batteries. Use two
new AA batteries as replacement batteries.
Remove the battery cover.
While press the knob, lift up.
1
2
Insert the batteries.
cCaution:
Check the (+) and (-)
indications inside the
battery compartment and
insert the batteries so
that they face correctly.
Install the battery cover.
Insert the tab
Press down until the battery
cover clicks into place.
1
2
3
2
1
■ Operating range (horizontal)
Using the remote control
Remote control light-receiving area
■ Operating range (vertical)
Operating distance
Approx. 10m
Operating distance
Approx. 10m
Operating distance
Approx. 10m
Remote control
light-emiting area
Approx. 30°Approx. 30°
Approx. 30°
Approx. 30°
Approx. 30° Approx. 30°
Approx. 30°
Approx. 30°