Filter
Top Products
15
Projecting Images
Basic
Operations
When the expected images are not projected
If more than one signal source has been connected, or if no images are projected, use the remote control or the
projector's control panel buttons to select the signal source. For video devices, press the [Play] button on the video
equipment first, then select the signal source.
Using the remote control Using the control panel
Press the button that has the name of the port on it that
the desired signal source is connected to.
When you press , the menu is displayed.
Use or to select the signal source.
Press to accept.
Using the remote control
While projecting an image from equipment
connected to the [InputA] port, press to
display the menu.
Using the control panel
While projecting an image from equipment
connected to the [InputA] port, select "InputA"
and confirm to display the menu.
The default setting is set to "Auto" to select appropriate signals automatically. However, if the colours appear unnatural,
switch the image signal to match the equipment.
Use or to select the correct signal to
match the equipment.
Press or to accept.
When projecting an image from the [Input A] port
Turning the power off
1
2
4
3
Turn the power off for the signal sources
that are connected to the projector.
When the projector has cooled down (takes
about 30 seconds), turn off the main power
switch.
Simply pressing or does not stop
electricity consumption.
Press on the remote control or on
the projector's control panel. If you press
on the projector's control panel, the
following message will be displayed.
Press again to continue.
Attach the lens cover.