Filter
Top Products
31
Configuration Menu Functions
Configuration Menu
"Signal" menu
This lets you set the lamp brightness to one of two settings.
Select "Low" if the images being projected are too bright such as when projecting images in a dark room
or onto a small screen. Use of "Low" prolongs the life of the lamp, and reduces the amount of power and
noise produced by fan rotation during projection.
The amount of light is adjusted appropriately depending on images (On)/ or not adjusted (Off). p.23
This returns all settings in the "Image" menu to their default settings.
Selects the aspect mode. p.18
This can be set only when "Aspect" is set to "Zoom".
This function enables the image to be reduced in size in the vertical direction so that the top and bottom
of images that are hidden from view can be viewed when "Zoom" is set. The larger the adjustment value
(reduction ratio) set here, the more the image is compressed and displayed squashed in the vertical
direction.
This can be set only when "Aspect" is set to "Zoom".
This function moves the display position of the image in one direction, up or down, to display captions
when projecting images with captions.
This adjusts the images if vertical stripes appear in the images.
This adjusts the images if flickering, fuzziness or interference appear in the images.
• Flickering and fuzziness may also occur when the brightness, contrast
and sharpness settings are
adjusted.
• Clearer adjustments can be obtained if you adjust the "Tracking" first and then adjust the "Sync".
(Setting is not possible when signals are being input from the [HDMI] input port.)
When part of the image is clipped, move the image display position vertically and horizontally so that the
entire image is projected. Press , , and to adjust the position.
This sets automatic adjustment to on or off in order to set whether the projector automatically adjusts
images to their optimum condition when the input signal is changed. The three automatically adjusted
items are "Tracking", "Position" and "Sync."
Only displayed for Computer input
(does not appear when signals from the [HDMI] input port are being input)
Brightness Control
*2
Auto Iris
*3
Reset
Aspect
*1
Zoom Size
*1
Zoom Caption Pos.
*1
Tracking
*1
Sync.
*1
Position
*1
Auto Setup
*1 The setting values are stored separately for each image source and signal type.
*2 The setting values are stored separately for each image source and colour mode setting.
*3 The setting values are stored separately for each colour mode setting.