Filter
Top Products
Control Panel 47
3
3
3
3
3
3
3
3
3
3
3
3
Changing default settings
Follow these steps to enter the default-setting mode and change
the printer’s default settings:
Note:
❏ To print the language selection and default-setting mode
instructions, you need five sheets of A4 or letter size single-sheet
paper or five pages of continuous paper that is at least 279 mm (11
inches) long and 210 mm (8.3 inches) wide. See “Loading
Continuous Paper” on page 5 and “Loading Single Sheets” on page
12 for instructions on loading continuous paper and single sheets.
❏ If you use single sheets, you need to load a new sheet of paper each
time the printer ejects a printed sheet from the paper guide.
1. When using continuous paper, make sure paper is loaded and
the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise, you may damage the
printer.
2. Turn on the printer while holding down the Load/Eject and
Pause buttons.
The printer enters the default-setting mode. When using
continuous paper, the printer prints the language selection
instructions (one page).
3. When using single-sheet paper, load paper to the printer. The
printer prints the language selection instructions (one page).
4. Press the LF/FF button several times until the Power, Paper
Out and Pause lights indicate the language you want, as
described in the language selection instructions.