Filter
Top Products
EPSON Stylus Photo R300 Series
12 - EPSON Stylus Photo R300 Series 10/03
5. Once the pattern is done printing, examine the first row or
set of lines (marked
#1). Select the line (1-15) in which all
the vertical dots are best aligned.
6. Use the and buttons to display the number of that
line (1-15), then press
OK.
7. Repeat the selection of the best line for set #2, set #3, and
then for set #4.
8. When you’re finished, press
OK.
Transporting the Printer
If you move your printer some distance, you need to prepare it
for transportation in its original box or one of a similar size.
To avoid damage, always leave the ink cartridges
installed when transporting the printer.
Follow these steps:
1. Turn on the printer, wait until the print head locks in the
far right position, then turn off the printer.
2. Unplug the power cord from the electrical outlet. Then
disconnect the printer cable from the printer.
3. Remove any memory cards from the printer and close the
memory card cover.
4. Remove any paper from the printer, push down the paper
support extension, and close the paper support.
5. Open the printer cover. Secure the ink cartridge holder to
the printer with tape as shown, then close the printer cover.
6. Make sure the CD/DVD tray guide is closed, then push in
the output tray extension and close the tray.
7. Repack the printer and its attachments in the original box
using the protective materials that came with them. See
your Start Here sheet.
Keep the printer level as you transport it.
After transporting the printer, remove the tape securing the
print head and test your printer. If you notice a decline in
print quality, clean the print head (see page 11); if output is
misaligned, align the print head (see page 11).
Related Documentation
CPD-17018 EPSON Stylus Photo R300 Series User’s
Guide
CPD-17016 EPSON Stylus Photo R300 Series Start
Here
CPD-17017 EPSON Stylus Photo R300 Series Quick
Reference guide
CPD-17019 EPSON Stylus Photo R300 Series
CD-ROM with electronic Reference Guide
Tape the ink
cartridge
holder to the
printer case