Filter
Top Products
EZ-Tear Thermal Printer
Owner’s Manual
1.6 Changing Paper
Caution: Do not operate the printer if it runs out of paper. The printer will not operate
without paper, but it may continue to accept data from the host computer. Because the
printer cannot print any transactions, the data may be lost.
1. Open the top cover by pulling under the tab on both sides.
2. Remove the used roll.
3. Tear off the end of the new roll so that the edge is loose and place the new roll into
the spindle bracket with a few inches of loose paper at the bottom of the roll.
Figure 5: Loading Paper
Caution: The tear blade has sharp corners and caution should be exercised when
loading paper not to cause personal injury.
Notice: Be sure the paper unrolls from the bottom. Otherwise, the printer will not
Print.
Optional
Spindle bracket
A
lignment
Tabs
102136
July, 2005
6