Filter
Top Products
EZ-Tear Thermal Printer
Owner’s Manual
Printer Does Not Work
Problem
Possible Causes What to Do
Check that printer cables
are properly connected
on both ends.
Printer not plugged in.
Check that the host or
power supply is switched
on. Check Printer LED.
Printer Does Not
Function When Turned
On.
Door not fully
Closed or paper not
loaded.
Close the door and load
paper.
Table 4: Printer Does Not Work
2. Media and Supplies Guide
2.1 Thermal Paper Specifications
The printer requires qualified thermal paper with the following dimensions:
Width Diameter
80 mm ± .2 mm (3.15 in. ± .008 in.)
or 65mm ± .2 mm ( 2.60 in. ± .008
in.)
152.4 mm max. (6 in.) when
using spindle, 101.6mm max
(4 in.) when using bucket
Table 5: Thermal Paper Dimensions
The paper must not be attached to the core. If Top of Form Option is installed, paper
with a black stripe (20% max reflectance) at the end of the roll can be used to indicate
that the paper is running low.
2.2 Ordering Thermal Paper
We recommend the following paper grades. There are a number of paper converters
qualified to supply this paper, provided the rolls are from these recommended grades.
Contact a Nanoptix sales representative if more information is required.
Manufacturer Numbers Paper Grade
Kanzaki Specialty Papers
(USA)
Tel: 888-526-9254
Fax: 413-731-8864
P-310 (Standard Sensitivity)
P-350 (High Sensitivity)
Table 6: Ordering Thermal Paper
102136
July, 2005
10