Filter
Top Products
EPSON LQ-300
1. Make sure the printer is turned off and the paper-release
lever is pushed back to the single-sheet position. Raise the
4. Slide a sheet of paper down firmly between the edge
paper guide upright.
guides until it meets resistance. The printer loads the
sheet automatically.
While hokling down the
LF/FF
button turn on the printer.
Release the button
after the
Pause light flashes. The
beeper sounds three times, indicating the printer is out of
paper*
Slide the left edge guide until it locks in place at the
triangular guide mark Next, adjust the right edge guide
to match the width of your paper.
’
RI
Caution:
Always close the printer cover while the printer is printing.
5.
6.
The
printer
cm&
helps the paperfeed
prqxrly.
To stop printing temporarily, press the Taupe button
To end the self test, make sure the printer is not printing.
Press
LF/FF
to elect the sheet; then turn off the printer.
Setting Up Your software
Most software lets you specify the type of printer you use so
that you can take full advantage of the printer’s features.
Your software probably provides an mstallation or setup
section that includes a list of printers.
Microsoft
®
Windows
™
3.1 and all Windows
progr;ilms
If Windows is installed on your computer system, follow the
steps below to install the right driver for your printer. Your
printer will work correctly for all your Windows programs,
such as Word for Windows, Lotus”
l-2-3”
for Windows, and
CorelDRAW?
If Windows is
mt
already installed on your system, run the
Windows setup program as described in the documentation
that comes with the program. Follow steps 4 through 10
below when you reach the section about choosing a printer.
1. In the
Main
window, double click the
Control Panel
icon.
2. Double click the
Printers
icon.
3.
Choose the
Ad&>
button.
EPSON LQ-300-8
10/2/94
Dot Matrix Printers