Filter
Top Products
1-16 Setting Up the Printer
2. While holding down the FEED button, turn on the printer using
the switch on the front of the printer to begin the self test. The
self test prints the printer settings and then prints the
following, cuts the paper, and pauses. (The PAPER OUT light
blinks.)
Self test printing.
Please press the PAPER FEED button.
3. Press the FEED button to continue printing. The printer prints a
pattern using the built-in character set.
4. The self test automatically ends and cuts the paper after
printing the following:
*** completed ***
The printer is ready to receive data as soon as it completes the self
test.
Note:
If you want to pause the self test manually, press the
FEED
button. Press the
FEED
button again to continue the self test.
Running the self test with slip paper
1. Make sure the printer is turned off and the printer cover is
closed properly.
2. While holding down the REVERSE button, turn on the printer to
begin the self test. (The SLIP light blinks.)
3. Feed a sheet of slip paper into the printer. The printer loads the
paper automatically, prints the printer settings, and then ejects
the paper.
H5po1r3.fm Page 16 Tuesday, July 14, 1998 12:31 PM