Filter
Top Products
Troubleshooting 3-9
Self mode
1. Load paper roll into the printer.
2. Turn off the power.
3. Open the front cover.
4. Turn the power back on while holding down the RELEASE
button.
5. Press the RELEASE button four times.
6. Close the front cover.
7. The printer prints the following message on receipt paper and
the SLIP LED flashes.
8. If you are using the adhesive cleaning sheet, remove the tape,
as shown below.
CAUTION:
Do not remove any other area of the paper besides the tape.
Remove tape here
H5po3r1.fm Page 9 Tuesday, July 14, 1998 12:33 PM