Filter
Top Products
Dip Switch and Paper Near End SettingsA-5
Print Density and Low power consumption mode selection (Only
for Receipt)
Notes:
•
When pin 6 of the interface connector is used for the reset signal, the printer is
reset at MARK on the RS-232 level.
•
When pin 25 of the interface connector is used for the reset signal, the printer
is reset at SPACE on the RS-232 level or at HIGH on the TTL level.
•
Changes in DIP switch settings (excluding switch 2-8 interface reset signal) are
recognized only when the printer power is turned on or when the printer is
reset by using the interface. If the DIP switch setting is changed after the
printer power is turned on, the change does not take effect until the printer is
turned on again or is reset.
•
If you turn on DIP switch 2-8 while the printer is turned on, the printer may be
reset, depending on the signal state. DIP switches should not be changed
while the printer power is on.
•
If the print density is set to level 3 or 4, the printing will be at the low speed.
•In a low power consumption, printing speed is fixed to 70 mm/sec.
Print Density SW 2-3 SW 2-4
Low power consumption mode ON ON
1 (Light) OFF OFF
2ONOFF
3 (Dark) OFF ON
H5poar2.fm Page 5 Tuesday, July 14, 1998 12:34 PM