Filter
Top Products
8 EPSON S5U1C63000H2 MANUAL
(S1C63 FAMILY IN-CIRCUIT EMULATOR)
CHAPTER 3: CONNECTION
3.4 Installing Peripheral Circuit Board (S5U1C63xxxP)
By installing the S5U1C63xxxP peripheral circuit board (to be separately sold) into a slot of the
S5U1C63000H2, a debug system can be made corresponding to each device of the S1C63 Family. Figure
3.4.1 shows installing method of the peripheral circuit board. The S5U1C63000H2 is equipped with a
main control board and a LCD drive board.
S
5
U
1
C
6
3
0
0
0
H
2
(1), (4)
(2)
Peripheral circuit board
(2), (3)
Fig. 3.4.1 Installing method of the peripheral circuit board
(1) Unfasten the screws located on the left and right sides of the front panel of the S5U1C63000H2 by
turning them counterclockwise, then remove the front panel.
(2) Insert the peripheral circuit board into
the uppermost slot and push it using the
jig attached with the S5U1C63000H2 as
shown in Figure 3.4.2.
Using this jig as a lever, push it toward
the inside of the board evenly on the left
and right sides. After confirming that the
peripheral circuit board has been firmly
fitted into the internal slot of the
S5U1C63000H2, remove the jig.
Peripheral circuit board
Fig. 3.4.2 Installing the peripheral circuit board
(3) Dismounting peripheral circuit board
Set the jig into position as shown in
Figure 3.4.3. Using this jig as a lever,
push it toward the outside of the board
evenly on the left and right sides and
pull the peripheral circuit board out of
the S5U1C63000H2.
Peripheral circuit board
Fig. 3.4.3 Dismounting the peripheral circuit board
(4) Mounting the front panel
Mount the front panel removed at the
step (1) on the main case by pushing and
turning two screws located at both side.
(5) The jig has a magnet for keeping under the bottom plate of the case while not in use.