Filter
Top Products
Introduction 13
Front section - S30670
1 Maintenance cover (left)
Open this cover to clean the area around the print head. Normally closed when using the printer.
See “Cleaning Around the Print Head” on page 126.
2 After heater
The heater can be used to rapidly dry ink after printing.
See “Heating & Drying” on page 97.
3 Roll core holder
Place the used roll core for media take-up on these holders. There are two holders: one on the left and one on the right.
See“Media Loading and Take Up” on page 82.
4Tensioner
The tensioner maintains tension to prevent the media sagging as it is taken up.
5 Roll core holder locking screw
The locking screws keep the roll core holders in place once they have been attached to the roll core. There are two locking
screws: one on the left and one on the right.
6 Roll support
Rest media temporarily on these supports when removing the take-up roll. There are two supports: one on the left and one on
the right.
7Auto switch
Use this switch to select the auto take-up direction. Choose Off to disable auto take-up.