Filter
Top Products
Introduction 18
Back
7Caps
Except during printing, these caps cover the print head nozzles to prevent them from drying out. We recommend that the caps
be cleaned once a week.
See “Regular Part Cleaning” on page 124.
8Wiper
The wiper removes ink from the print head nozzles. We recommend that this unit be cleaned once a week. It is included in the
maintenance kit and needs to be replaced about once every six months (or more often, depending on usage).
See “Regular Part Cleaning” on page 124
See “Replacing the Wiper and Wiper Cleaner” on page 135.
9Flushing pad
Ink is discharged onto this pad during flushing. It is included in the maintenance kit and needs to be replaced about once every
six months (or more often, depending on usage).
See “Replacing the Flushing Pad” on page 138.
1Drive switch
The drive switch is used to feed the media during loading and to rewind the media for replacement.
2 Roll holder
Place media on these holders. There are two holders: one on the left and one on the right.
3 Roll holder fixing screw
These screws fix the roll holders in place once the media has been installed. There are two screws: one on the left and one on
the right.
4 EPSON LiftAssist lever
If the media to be mounted on the roll holders seems heavy, use these levers to raise the media effortlessly to the level of the
roll holders. There are two LiftAssist levers: one on the left and one on the right.