Filter
Top Products
Basic Operations 49
20.Close the front cover.
Using the Optional Heavy Roll Media Feeding Unit
This section uses the S70670 to illustrate how to load media when the optional heavy roll
media feeding unit is installed.
We recommend using a lifter for media over 40 kg (88.2 lb).
The explanation that follows assumes that a lifter is used.
The following types of lifter can be used.
❏ Fork or platform thickness: 28 mm (1.10 inches) or less
❏ The fork or platform can be lowered to approx. 190 mm (7.5 inches) from the floor.
1. Turn on the printer by pressing the P button.
Important:
❏ Do not use the media holding plates with media that is more than 0.4 mm (0.02 inch)
thick. The media holding plates could touch and damage the print head.
❏ Move the media holding plates to the left and right edges of the platen when they are
not in use.
❏ Do not use the media holding plates if the sides of the printed media are smudged or
torn.
❏ Leave left and right margins of over 10 mm (0.39 inch) when using the media holding
plates. Narrower margins could result in printer printing over the plates (this does not
apply when ink layering is used).
c
Caution:
Because the media is heavy, it should not be carried by one person. When loading or
removing the media, use at least two persons. Using a lifter is recommended when
handling a media that is 40 kg (88.3 lb) or heavier.