Filter
Top Products
TM-L90 User’s Manual 5
English
Installing Horizontally or Vertically
You can install the printer horizontally (with the paper exit on top) or
vertically (with the paper exit at the front) either on a flat surface or by
hanging it on a wall (using the optional hanging bracket set, WH-10).
Both the horizontal and vertical positions are shown below.
When you install the printer horizontally, attach the control panel
label and position the roll paper near end sensor as shown in the
illustrations. To move the sensor, follow these steps.
1. Loosen the screw with a coin or similar tool
and turn it at least 3 or 4 times.
2. Push the lever gently as far as it will go.
3. Turn the tab (in the direction of the arrow in
the illustration) while pushing the lever until it
clicks into place in hole A.
4. Secure the screw and make sure the lever moves smoothly.
Note:
To hang the printer on the wall, see
the Wall Hanging Bracket Set
Installation Manual provided with the
WH-10 for instructions.
tab
screw
A