Filter
Top Products
6 TM-L90 User’s Manual
English
Installing the Paper Roll
When you use the printer horizontally, peel off the backing sheet of the
paper exit guide and attach it as shown below to prevent cut paper
from falling inside the printer after paper is cut by the autocutter.
Note:
If you use roll paper with a
core that is smaller than
the specifications (inside
diameter of at least 25.4
mm and outside diameter
of at least 31.4 mm), be
sure not to attach the paper
exit guide. Otherwise a
paper jam might occur.
Be sure to use paper rolls that meet the specifications.
1. Open the paper roll cover, using the cover open lever.
2. Insert a paper roll and pull out a small amount of paper, aligning
the paper with the guide, as shown below.
3. Close the paper roll cover; then tear off the roll paper.
paper
exit
guide