Filter
Top Products
Adjusting the Projected Image
164
D To adjust the shape, use the [h] button on the remote
control or the [w/ ], [v/ ], [</ ], and [>/ ] buttons on
the control panel.
If the triangle in the direction you are adjusting the shape turns
gray, as shown in the screenshot below, you cannot adjust the shape
any further in that direction.
E Repeat steps 3 and 4 as needed to adjust any remaining
corners.
F When you are done, press the [Esc] button to exit the
correction menu.
Because the correction method was changed to Quick Corner from
Geometric Correction in the configuration menu, when [w/],
[v/], [</ ], and [>/ ] buttons are pressed later, the screen
for selecting the corner in step 2 is displayed. Change Geometric
Correction from the configuration menu to H/V-Keystone if you
want to correct H/V-Keystone when pressing the [w/], [v/],
[</ ], and [>/ ] buttons on the control panel. s p.65
q
If the [Esc] button is held down for about two seconds while correcting
with Quick Corner, the confirm default reset screen is displayed.
Select "Yes" to reset the result of Quick Corner corrections.
H/V-Keystone
Procedure
Press the [w/ ], [v/ ], [</ ], and [>/ ] buttons on the control
panel to adjust keystone settings in the horizontal and vertical di-
rections independently.
q
This adjustment can also be made from Geometric Correction -
H/V-Keystone on the Settings menu. s
p.65