Filter
Top Products
USER GUIDE
© Escort Data Logging Systems LTD DATED: 03/07/07 PAGE 9
Out of Specification Readings
Below illustrates an example for an internal sensor logger (not to scale):
Ser# 9443/0023 TRIP:4 Logger Serial number & trip number
Battery OK
Battery Status of Logger
Pool Water Test
Description of log
-----------------------------
Internal Temp
Sensor Type
Upper Spec : 30.0°C The upper and lower specifications of the sensor
Lower Spec : 20.0°C
-----------------------------
1995 01/03 16:12:29
Last log time
Out of Specification
Times are Sender LOCAL
Time zone
01/03 06:27:29* 19.5°C
List of out of specification readings
01/03 06:22:29* 19.7°C
01/03 06:17:29* 19.5°C
01/03 06:12:29* 19.2°C
01/03 06:07:29* 19.5°C
2000 Samples
-----------------------------
Log Summary : provides breakdown of log as
Above Specification:
per the upper/lower specification & summary
30.0->32.0°C : 100 mins increment specified for the logger.
Above 32.0°C : 45 mins
Below Specification:
20.0->18.0°C : 55 mins
Below 18.0°C : 5 mins
-------------------------------------------
Notes
• If the logger has two sensors (such as a EJ-IE or EI-HS loggers) then the other sensor’s
specifications and log summary will also appear if the sensor is enabled for logging.
For EJ-IE & EJ-HS loggers, the list of out of specification readings will contain a sensor
label at the beginning of each line. (“I” for internal sensor, “E” for external sensor and “H”
for humidity).
• During the printing of out of specification readings, the printer may pause at times while
the ChartReader scans through the logged readings in search of out of specification
values.
• If during printing the paper runs out, the out of specification print indicator will flash rapidly
and beep, printing will pause. The user can either install a new roll of paper and push the
print button to resume printing or press the CANCEL
key to abort printing.
• In case the battery voltage drops to an unacceptable level during printing, the out of
specification print indicator will flash rapidly and beep, printing will pause. The user can
either plug in external power and push the print button to resume printing or press the
CANCEL
key to abort printing.