Filter
Top Products
Electrical Interface
35 LRP2000 Passive Reader/Writer
3.9.2 DIP Switch Settings on the Slave
To set a LRP2000 to operate as a slave in a dual antenna installation, you must change the settings of DIP
switch banks S1 and S2.
For reference, Table 6 shows the settings for a master LRP2000. The correct settings for switch banks S3
and S5 are also shown. Figure 33 shows the locations of the switch banks.
Figure 33: DIP Switch Banks S1, S2, S3, and S5
Table 6: Master DIP Switch Settings
Bank Position 1 Position 2 Position 3 Position 4 Position 5 Position 6 Position 7 Position 8
S1 OFF OFF OFF OFF OFF ON OFF OFF
S2 ON ON OFF ON OFF OFF OFF ON
S3 OFFONONONOFFOFFONON
S5 ON ON ON ON ON ON ON ON
S1
S2
S3
S5