Filter
Top Products
Installing the Tape Drive
5
1. Remove the four screws that secure the drive to the bottom of the
mounting sled (see Figure 1-1) and set them aside.
Figure 1-1 Removing/Installing the Drive From/On the Drive Sled
2. Remove the drive adapter and power cables from the 8505XL (see
Figure 1-1) and then place the drive on an anti-static surface.
3. Locate the SCSI ID jumper block on the back of the tape drive (see
Figure 1-2).
Data
connector
cable
Power
connector
Drive sled
SCSI channel
adapter board
A
Exabyte drive