Filter
Top Products
Contact vs. Non-Contact Measurements
In using any infrared temperature device, closer is always better, as the
field of view increases proportionately to the distance from the surface.
Accordingly, for maximum accuracy the probe must contact the sur-
face at the point of interest. It does not need to be tightly pressed to the
surface; a gentle touch is all that is required.
When contact with the surface is not an option, position the probe within
1/2 inch from the surface of interest. If using a non-contact protocol,
the relative temperature indication of the instrument will be accurate.
4
Release pinch. Pull box slightly away
until next white ring is visible. Pinch
ring, break film apart at perforation.
3
Rotate instrument into film until probe
faces opposite direction, push ring on
peg.
1
Start with film perforation at edge of
box tongue. Pinch bottom of white
ring, push ring over peg.
2
S
to
p
at Per
f
orat
i
on
Release pinch, gently pull box away
from probe to release film from box.
Pinch just below next ring, before per-
foration.
3
Instructions for Applying Disposable Covers
Model 1001 LT Only