Filter
Top Products
APPENDIX A
- 31 -
S37:000 S90:000 S108:002 S109:062S37:000 S90:000 S108:002 S109:062
Telephone Numbers:Telephone Numbers:
&Z0 12345&Z0 12345
&Z1 T4444444&Z1 T4444444
&Z2 T12345&Z2 T12345
&Z3 T 1 (123) 456-7890&Z3 T 1 (123) 456-7890
&W 00 Store active profile in user profile 0Store active profile in user profile 0
11 Store in Store in active profile user profile 1 user profile 1
&Y 0* Select stored profile 0 on power up
1 Select stored profile 1 on power up
&Zn=x none Store telephone number
To dial the stored telephone, use theTo dial the stored telephone, use the
ATDS=n command.ATDS=n command.
x = 0, 9, A, B, C, D, #, *, T, P, R, W, @, ,,!,;x = 0, 9, A, B, C, D, #, *, T, P, R, W, @, ,,!,;
n = 0-3n = 0-3
%E 0 Disable Auto-retrain ( V.32 and V.32bis Only)
1 * Enable Auto-retrain
%G0 0 * Disable Auto Fallforward/fallback Rate Renegotiation
1 Enable Auto Fallforward/fallback Rate Renegotiation
%Q none Line signal quality
Range: 0-255Range: 0-255
0 - 7 No Retrain0 - 7 No Retrain 8 - 255 Modem performs a Retrain (i.e., if configured for %E1)8 - 255 Modem performs a Retrain (i.e., if configured for %E1)
-Cn 0* Diable data modem calling tone
1 Enable data modem calling tone
* Value saved in NVRAM.
V.42, MNP 'AT' Commands
Command Default Function
%A 13 Set auto-reliable fallback character
%C 0 No data compression
1* MNP 5 data compression control
\A 00 MNP block size Maximum 64 characters Maximum 64 characters
11 MNP block size Maximum 128 characters Maximum 128 characters
22 MNP block size Maximum 192 characters Maximum 192 characters
3*3* MNP block size Maximum 256 characters Maximum 256 characters
\Bn none Transmit break (n=0-9 Break lenght in 100 msec)
\C 0* Does not buffer data
11 Buffers data for four seconds until 200 characters have been buffered or SYN character is detected, then switches to reliable mode. If the buffer fills,Buffers data for four seconds until 200 characters have been buffered or SYN character is detected, then switches to reliable mode. If the buffer fills,
data is passed to the serial port.data is passed to the serial port.
22 Does not buffer data. Switches to normal mode upon receipt of auto-reliable fallback character and passes it to serial port. This feature is used toDoes not buffer data. Switches to normal mode upon receipt of auto-reliable fallback character and passes it to serial port. This feature is used to
allow non-V.42 modems to connect immediately to a V.42 modem without data loss.allow non-V.42 modems to connect immediately to a V.42 modem without data loss. Set auto-reliable buffer
\G 0 * Disable modem port flow control
1 Set port flow control to XON/XOFF
\Jn 0 * Disable Bps rate adjusting