Extreme Networks WM-4T1i Network Router User Manual


 
WM-4T1i Module Installation and User Guide 1-5
Installing the WM-4T1i Module Software
The slowly blinking LEDs cycle once per second. The rapidly blinking LEDs cycle twice
a second.
Installing the WM-4T1i Module Software
Once the WM-4T1i module is installed in the chassis, you must download an image file
to the module.
The image file contains the executable code that runs on the module. As new versions
of the image are released, you should upgrade the software running on your module.
The image is downloaded from either a Trivial File Transfer Protocol (TFTP) server on
the network or from a PC connected to the serial port using the XMODEM protocol.
Downloading a new image involves the following steps:
Load the new image onto a TFTP server on your network (if you will be using
TFTP).
Load a new image onto a PC (if you will be using XMODEM).
Download the new image to the module using the command
download image slot <slot> [<ipaddress> | <hostname>] <filename>
{primary | secondary}
where the following is true:
slot Is the slot in which the WM-4T1i module is installed.
ipaddress Is the IP address of the TFTP server.
hostname Is the hostname of the TFTP server. (You must enable DNS to use this
option. See the ExtremeWare Software User Guide for more information.)
filename Is the filename of the new image.
primary Indicates the primary image.
secondary Indicates the secondary image.
The module can store up to two images; a primary and a secondary. When you
download a new image, you must select into which image space (primary or secondary)
the new image should be placed. If not indicated, the primary image space is used.
You can select which image the switch will load on the next reboot by using the
following command: